latknowledge.blogg.se

The MAC address table does not contain any sticky MAC address, no Parameters, all sticky MAC address entries are displayed. If you run the display mac-address sticky command without Or the learned sticky MAC address entries, run the display mac-addressĭisplayed sticky MAC address entries are invalid, run the undo mac-address command to delete sticky MAC address entries. Sticky MAC address entriesĪre not deleted after the router restarts. Mac-address sticky command, secure dynamic MAC addressĮntries change to sticky MAC address entries. MAC function is also enabled on the interface by using the port-security Learned secure dynamic MAC address entries are deleted after the router restarts. In the MAC address table as secure dynamic MAC address entries. Is enabled on an interface by using the port-security enable command, MAC address entries learned by the interface are stored Table for the outbound interface according to the destination MACĪddress and VLAN ID in the Ethernet frame. When forwarding an Ethernet frame, the router searches the MAC address The MAC address table of the router stores MAC addresses Table does not contain any static MAC address entry, no information

Run the display mac-address static command without parameters,Īll static MAC address entries are displayed. Is incorrect, run the undo mac-address command to delete it. The display mac-address static command to verify the configuration. After configuring static MAC address entries, you can run With bogus MAC addresses and guarantees communication between the router and the upstream device To improve network security, configure static MAC addressĮntries to ensure that packets destined for specified MAC addressesĪre forwarded by the specified interfaces. With the specified source MAC addresses or destination MAC addresses.īlackhole MAC address entries are manually configured and will not If the MAC address table does not containĪny blackhole MAC address, no information is displayed. MAC address entry in the command output is incorrect, run the undo mac-address command to delete the entry or run the mac-address blackhole command to add a correct one.īlackhole command without parameters, all blackhole MAC address These entries ensure communication between To check whether blackhole MAC address entries are configuredĬorrectly, run this command. Dynamic MAC address entries that are learned by the router and will be aged out.Static MAC entries that are manually configured and will not be.MAC address entries are manually configured and will not be aged out. With the specified MAC addresses or destination MAC addresses. Blackhole MAC address entries that are used to discard packets.Contains the following MAC address entries: